How to setup the toolbox scan-1 / scan-2 button functions these functions start the linked application program after the scan is complete and pass the image file to it. by default, the scan-1 button starts photostudio (the scan-2 button is not linked to any software by default).. This method uses the canoscan toolbox buttons to scan 35 mm film strips and slides in a few simple steps scanning films with scangear cs in simple mode this method summons the scangear cs driver window from an application program and scans films in simple mode, allowing you to adjust a few settings.. Hi, i have a canon 8400f scanner and downloaded the canoscan toolbox. when i try to use the scanner, i get the following message "specify the program where the scanned image is transferred". no matter what i attempt to do, i can't designate a program to get the scanner to work..
To use the canoscan toolbox mail function, one of the following e-mail programs should be installed. for windows: microsoft outlook express, microsoft outlook, eudora or netscape messenger. (some mail programs are required to set the mapi function on. refer to the operating manual of the mail program for setting mapi.) for macintosh: mail, eudora or ms entourage. 1. open scangear toolbox. Canoscan toolbox is a software utility which will help make using your scanner easier. the canoscan toolbox application makes the buttons on the front panel works now too.. I have downloaded the canon 4.9 toolbox, but when i try to scan a photo, i am asked to specify the programme for the image to be transferred to. the arcsoft progamme has gone, and i don`t have another photo editing programme installed..